The method of lithium battery solar street lamp installation is as follows:
A: pouring basic: buried embedded parts. Solar street lamp LED lamp head wire lithium control battery white cap separated, wiring attention to use electrical tape wrap. Take the 6-meter solar street lamp as an example: the size of the embedded pit should be 500*500, and the depth should be 60 cm. Leave the position of the screws on the number, stick them with rubber strips (to avoid sticking concrete on them), and bury them for pouring.
2: solar street light system wiring: 1: storage and control integrated lithium battery and LED lamp wiring method: load output: positive and negative (red line represents positive, black line represents negative); The positive pole is connected with the positive pole of the LED lamp, and the negative pole is connected with the negative pole of the LED lamp. Solar street lamp LED lamp head wire lithium control battery white cap separated, wiring attention to use electrical tape wrap. 2: lithium battery and solar panel wiring method, solar input: positive and negative poles; The positive electrode is connected to the positive electrode of the solar panel, and the negative electrode is connected to the negative electrode of the solar panel.
Three: there is a connection wire, check the charging abettor light (green G) is abnormal light; Such as malformed light, 10 seconds after the unplug solar input, load output LED light malformed light; Connect the solar input again, and the load output LED lamp will burn after 10 seconds. LED street lamp it is a kind of efficient solid state light source based on semiconductor PN junction formed with weak electric energy can emit light, in a certain forward bias voltage and injection current, injected into the hole in the P region and injected into the N region of electrons in the diffusion to the active region after radiation compound and emit photons, the electric energy directly into light energy. It is a solid cold light source, with environmental protection, no pollution, less power consumption, high light efficiency, long life and other characteristics, therefore, LED street lighting will become the best choice for energy-saving transformation.
Caution:
(1) Four screw holes are reserved between the lithium integrated battery device and the solar panel support.
(2) For the solar panel device, four holes are reserved in the solar panel support and screws are fixed in the reserved positions.
(3) Solar panel and lithium control integrated battery device support is realized, and the device is fixed on the top of lamp pole.
(4) The wiring on the back of the solar panel is reverse buckle design, and the screwdriver can be used to pry open it slightly. The wiring of the solar panel is positive and negative wire corresponding to the black cap of the lithium integrated battery, and the wiring is careful to be wrapped with electrical tape.
