The use of lithium battery solar street light rechargeable battery from the colloidal battery to lithium change, lithium solar light installation differs from the general solar light installation method. How to understand the lithium battery solar lights, people must first know and learn training under the lithium battery solar street light installation tutorial.
Today I'll let you a detailed introduction under the lithium solar lights how to install
A, lithium battery solar street light installation FAQ: lithium solar lights installation depends on people to be below but also all the system software test light to carry out, if the column to carry out, the upper wiring is not correct words overhaul is very inconvenient (lithium storage and control system wiring is very simple, its output has two lines, a connection to the solar photovoltaic panels, a connection to the light source, people only must first connect the solar panels, wait for 1 minute after Lithium battery storage control system fully automatic excitation, followed by people then connect the light source 1 minute will be fully automatic illumination; if not, worry, can immediately connect the solar panel light source, that can immediately demolish the solar panel of a negative level, 1 minute up and down will light, how can there be such a difference, depending on the lithium battery manipulation and general manipulation of the difference depends on, lithium batteries can be started with solar photovoltaic panels, while (general control board start must be the battery).
Second, lithium battery solar street light differences between the installation of colloidal solution and lithium batteries depending on the installation site of the rechargeable battery is different, the basic solar lights to the battery are buried in the ground, with moisture-proof box maintenance. Lithium battery is divided into two kinds of aluminum and plastic shell, aluminum shell installation is the use of hoop fixed immobile in the solar photovoltaic panels below, that can avoid theft can also reduce line loss. The plastic shell is people in the street light solar bracket welding 1 lithium placement iron box. This type of design solutions to reduce the cost of labor service installation fees and warm theft prevention design solutions, but there is a flaw, the installation of after-sales service is very inconvenient, so nowadays all with aluminum shell more.
Third, the lithium battery solar street light in the original factory before the power is not full, to avoid the whole process of delivery over the bad road appeared flammable occurrence of explosive conditions. Therefore, in the application of the whole process will appear dark bright condition, is the control board into the fully automatic adjustment of output power maintenance, please use people at ease. Lithium solar light application should pay special attention to the reasonableness of the equipped system software, which can reduce the after-sales maintenance service.
