The maintenance method of the manual hydraulic forklift oil pump is as follows: There are three gears in the manual hydraulic forklift generally. 1. The middle is the positioning gear, and the car in this gear neither rises nor falls. 2. Dial up is the neutral gear, that is, the descending gear and the pressure relief gear. 3. Dial down is to hang the gear, that is, to close the oil seal to make the hydraulic pressure rise. During maintenance, shift the gear of the manual hydraulic forklift up, and then press the handle a few times as usual. At this time, although the manual hydraulic forklift will not rise, it can remove the air in the pump, about 10-20 times. That's it.
The operation method of starting the forklift: 1. The operator tightens the parking brake, and the gear lever is set to the neutral position; 2. Turn on the ignition switch and connect the ignition circuit; 3. Press the clutch pedal with the left foot and accelerate with the right foot pedal, the gasoline engine should pull out the choke door and twist it, and turn the ignition switch key to the starting position to start; the diesel engine should rotate the start knob or button. 4. After the engine is started, after the idle speed of the engine is stable, release the clutch pedal, keep running at a low speed, and gradually increase the temperature of the engine. Do not step on the accelerator pedal hard to avoid excessive oil pressure and increased engine wear.
The method of turning off the forklift: When the forklift needs to be stopped after the operation, just turn off the ignition switch of the forklift and observe the swing of the ammeter pointer to determine whether the circuit has been cut off. Before stopping the engine, do not slam the accelerator pedal hard, this will not only waste fuel, but also increase the wear and tear of the engine. If the engine is turned off when the temperature is too high, first let the engine idle for 1-2 minutes to cool the parts evenly, and then turn off the ignition switch to stop the engine.
