China's new rural construction vigorously uses and install street lamps, especially solar lamps with huge advantages. But there is large and small solar street lamp configurations on the market, the price of solar street lamp is high and low, many people do not know how to choose, ** pre-south lighting will give you a brief introduction to the standard configuration of a solar street lamp.
In order to ensure the quality of solar street light on the LED light source to do a good job of electrostatic protection before welding, wear electrostatic ring, thermal conductivity silicone grease, thermally conductive silicone coating to ensure the even daub, ensure the heat lamp bead welding, and then check whether the solder joints have leakage welding, welding, welding phenomenon, board face welding slag is clean, check whether the lamp bead and aluminum plate joint in place, Is there any hanging phenomenon? If hanging, re-welding is needed to ensure heat dissipation of {zd0} degree.
In the battery selection in order to ensure the quality of the battery in the street lamp production performance of the same or similar batteries together, so should be classified according to its performance parameters; Battery testing is to classify batteries by measuring their output parameters (current and voltage). In order to improve the utilization rate of batteries, make qualified battery components.
For the current road lighting development in the process of street lamp production, solar street lamp manufacturers can only ensure the production quality of each component of the street lamp to achieve good road lighting.
Solar street lamps in the actual configuration process, specific requirements are different, so there may be some differences in the configuration process, in the selection process, on the one hand, according to the cost of investment, on the other hand, according to the different installation areas, choose the appropriate configuration of solar street lamps.
