Here is mainly to consider the life of LED light source and battery, the correct use of battery, life can reach more than 5 years, the so-called correct use of battery, refers to the solar street lamp manufacturers in the design and configuration, it is necessary to consider the bearing capacity of the battery.
If the solar panel power output is 45Ah every day, then the battery capacity must be larger than 45Ah, to avoid the deep discharge through the big impact on the storage capacity and life of the battery, the battery can choose more than 50Ah, here the regular manufacturer city choose a slightly larger capacity of the battery, And some small manufacturers blindly in order to reduce the price will choose a small point or just 45AH battery.
In addition, the solar control device has a timely switch of immersion, control the length of the street lamp on and off the lamp time, without it, the road lamp will have a problem. This is because the life of the solar street lamp panel can be as long as 25 years or more, the battery is three or five years that need to be replaced, if the maintenance is improper, resulting in frequent replacement of the battery, it will increase the cost of the street lamp.
The penetration of the solar controller in the solar street lamp system is not as direct as the panels and batteries, but it is indispensable. Its main soaking is to care for the charge and discharge of the battery, charging high voltage care, over discharge low voltage care, over current care, over voltage care, so as to maintain the battery, properly delay its service life, further reduce the cost of using solar street lamps.
Secondly, can also remove the solar lamp control, first, control cheap, convenient origin, convenient maintenance and maintenance, second, control is not broken, as long as according to the correct use of the copy, will not cause much threat.
Solar panels can last for more than 25 years, and light poles can last for more than 30 years.
Second is to carry out regular maintenance of solar street lights, such as winter rain and snow weather if snow accumulation to the solar panel to be cleaned up in time, summer to pay attention to the heat dissipation of LED street lamps. Anti-corrosion of all exposed parts of solar street lamps.
In addition, when cleaning the putty of the solar panel, you can use a clean mop to touch clean water, and pay attention not to use hard things to prevent scratches on the surface of the panel. If the solar street lamp has been used for a long time, the LED light is not enough, you can clean the dirt on the lampshade, clean the dirt in the contact part of the positive pole of the light source and the spring piece, so that it conducts electricity smoothly.
If it is found that the solar street lamp is damaged or cannot be used normally, it can be checked and repaired by the technical personnel of the solar street lamp manufacturer.
