Solar street light is now a more common lighting tool for us in the outdoor. In the future development will still extend the solar street light technology more. Its development prospects are vast. Here we will knot what should be noted in the installation of the problem.
A, solar street light unloading precautions
1. Unloading should be carried out gently to prevent scratching off the surface of the light pole paint.
2. The battery shall not be placed upside down, placed diagonally.
3. Pay attention to waterproof, as far as possible in the rain can not be placed.
Second, solar street light battery panel installation
1. Place the battery panel on the ground with the back side facing up. The following pad on the cardboard, to prevent grinding surface glass.
2. will have been measured and cut a good wire (length slightly longer than the pole) of the red line (or a relatively brightly colored line, in order to distinguish) and the positive pole of the battery panel junction box connected, wrapped in good tape. (Some junction boxes have out of line, some do not. No need to open the junction box inside the wiring.) Another wire and the negative terminal of the junction box is connected, wrapped in tape.
3. The battery plate bracket on the battery plate, the line from the sleeve through. Put the bracket and the battery board screw hole right, and fix it with screws. (The direction of the bracket's sleeve is opposite to the junction box)
4. Put the wire through the top of the pole, and screw the sleeve of the bracket into the top of the pole. One end of the line should go to the bottom of the pole.
Third, the installation of solar street light source
1. Measure the cut wire (length is slightly longer than the length of the light arm + installed light arm to the bottom of the pole) of the red line (or a relatively brightly colored line, so as to distinguish) and has opened the red line in the lamps and lanterns connected. The other one is connected to the black wire of the luminaire. (There are terminals directly into the terminal, screwed. No terminal wrapped with tape.)
2. Put the wire from the top of the lamp arm into the lamp arm, and fix the lamp on top of the arm.
3. Thread the wire from the arm to the bottom of the pole, and fix the arm. Adjust the direction of the lamps and lanterns (the light direction of the lamps and lanterns is straight towards the bottom of the pole)
Four, solar street light crane crane pole
1. Bolt the rope to the appropriate part of the pole.
2. When lifting, pay attention to the battery plate and the light do not collide with the crane arm. To avoid damage to the battery plate and lamp.
3. Pay attention to adjust the direction of the battery plate and the light arm.
4. The flange of the light pole and the foundation bolts butt, into the gasket, screwed to be fixed.
Five, solar street light battery installation
1. The battery box is divided into the upper cover and the lower cover. The lower cover is one with holes, the upper cover is not.
2. Put a casing connector on the hole of the lower cover and tighten it.
3. Take the battery out of the box, release the wire and put it into the lower cover. Put the wire through the connector.
4. Put the waterproof seal on the edge of the lower cover with the screw holes aligned. Then put the upper cover on. One by one, tighten the screws lemon well to achieve waterproof effect.
5. Put the wire out of the hose, and tighten the hose and the connector firmly with the holding band.
6. Put the installed battery box into the cement pit of the battery already made. Then put the hose and line through the back door from the line hole of the foundation.
